3M™ Cold Shrink Transition Splice Kit QS2012-3T-WS, Tape, Wire, UniShield®, EP-Lead or XLP-Lead, CN, JCN and PILC, 15 kV, 3/0 AWG-250 kcmil PILC and 4/0 AWG-500 kcmil poly/EPR, 1 kit/case
- 3M ID 80610982953
Details
Highlights
- Specially designed splice to connect a 3/C paper insulated lead covered (PILC) cable to three 1/C Poly/EPR insulated cables
- Poly/EPR cables include CN, JCN, LC, tape shield, wire shield, poly/EP lead or UniShield® cables
- Mastic components seal at Poly/EPR cable jacket ends
- Poly/EPR cable has 0.88 to 1.36-in insulation O.D
- Accommodates 4/0 AWG to 500 kcmil size Poly/EPR cable conductor
- Silicone rubber-splice body controls the electrical field of the high voltage over the connector
- Rated for 15 kV cables
- Meets the requirements of IEEE 404 standards
3M™ QS2011-3T-WS Series Cold Shrink Trifurcating Transition Splice Kit is a specially designed 15kV splice to connect a 3/C paper insulated lead covered (PILC) cable to three 1/C Poly/EPR insulated cables. Poly/EPR cables include CN, JCN, LC, tape shield, wire shield, poly/EP lead or UniShield® cables. It uses wraparound heat shrink rejacketing.
3M™ QS2011-3T-WS Cold Shrink Trifurcating Transition Splice Kit includes 2 bags with components to seal oil inside and to seal the phase conductors of the PILC cable. The kit contains cold shrink splice bodies, an overall shield sleeve, heat shrink breakout boot, moisture sealing mastic materials, ground braid connectors, copper ground braids, resin and a heat shrink wraparound jacket sleeve. It is suitable to use on cables that can withstand a maximum temperature of 90 degrees C. The kit meets the requirements of IEEE 404 standards.
Typical Properties
Resources
